Benko Products
 

“CLASS A” ELECTRIC OVEN

The National Fire Protection Association (NFPA, Bulletin 86) requires a special oven, defined as “Class A” when heating materials with flammable solvents. NFPA standards are also used by OSHA and insurance underwriters to meet their requirements.

A “Class A” oven must have the following features:

  • Forced exhaust (sized to keep the flammable solvent vapor concentrations below the lower explosive limit in the oven.)
  • A method to prove airflow (airflow switch)
  • Purge timer (works in conjunction with exhaust blower to purge the oven of volatiles before heaters are energized.)
  • Explosive relief area

FEATURES
• Rugged steel construction
• Precise digital temperature control
• Portable. Just pick up with a forklift
• Built-in spill containment

MATERIALS OF CONSTRUCTION
All steel construction includes 12 gauge interior walls and 14 gauge exterior walls. Integrated framing and structural members ensure toughness. Stainless steel available.

INSULATION
3 inch thick, 6 lb. density mineral wool in doors, roof, walls and floor.

TEMPERATURE RANGE
Room temperature to 350°F.

CAPACITY
One to 32 drums on pallets.

ELECTRICAL
Optional voltages. Optional kw ratings. Digital temperature controller with independent high temperature cut off.

AIR CIRCULATION
Air circulation available in any air flow pattern for temperature uniformity.

INSTALLATION
Unit is shipped completely assembled. Simply set in place and hook up power supply.

Request a Quote